[FRYNTYR]

Ran the nova for nearly three years without a gage. Nothing to read,,,,nothing to worry about.

It's still light out, you should be able to drive it up and down the road a few times.

 

[Kevin R]

Also if I dont drive it nothing can be worng. I think I will just start it up once in a while and listen to it idle Sounds wicked:yes:

 

[FourEightyNine]

Also if I dont drive it nothing can be worng. I think I will just start it up once in a while and listen to it idle Sounds wicked:yes:

Or you could not drive it and come up with things that need to be fixed that arent even broken........................................

 

[Kevin R]

Or you could not drive it and come up with things that need to be fixed that arent even broken........................................

Thats not a bad idea Brian

 

[Kevin R]

Hey guys I will get out and drive this thing:yes: I would like to get the oil line installed and I still need to check the valve adjustment. I still need to get the new throttle pedal and cable installed.

 

[FourEightyNine]

What about a burnout in the garage?!:hurray:

 

[Kevin R]

What about a burnout in the garage?!:hurray:

I already did that but didnt have the video camera charged You should of seen the smoke and fire:thumbsup:

 

[gotago]

Nothing to read,,,,nothing to worry about.

I can see why you have so many spare parts!!

 

[Kevin R]

Well I went searching for a reducer fitting for my oil pressure guage and no one has one that small. When I was at Carquest the guy showed me a kit with copper tubing that was only 21 bucks that would work as it has the correct fittings to work with my guage with no reducer needed. I may go back and just pick it up and hang the braided line on the wall for decoration

 

[FourEightyNine]

Drive it yet?!:thumbsup: Stop pullin a ...... on us

 

[kettbo]

Drive it yet?!:thumbsup: Stop pullin a ...... on us

George?

 

[Kevin R]

George?

Im sure thats what he ment George but it will take more than a little punk kid to stir me up It will be on the road soon enough. :yes:

 

[FRYNTYR]

This is killing me!!!!!!!

 

[Dave]

What Reducer do You need? I probably got one in My stash.

 

[Kevin R]

What Reducer do You need? I probably got one in My stash.

It would be a 1/16 female to a 1/8th male. I have the 1/16th male 1/8th male.

 

[FRYNTYR]

I have one factory one left if that's what you need. with the 45 degree angle

 

[Kevin R]

I have one factory one left if that's what you need. with the 45 degree angle

I need an adapter for the gauge itself. It has a male end coming out of the back of the gauge that is the same diam as the small compression fitting that you use with the nylon line and I think its 1/16th. The AN fitting adapter that comes with the kit has an 1/8th" female on the other side of the AN fitting side so It wont work with the gauge so I would need an adapter that I could put on the back of the gauge that goes from that size to the 1/8th male so that the AN adapter can go on that. Confusing??

 

[Dave]

You should need a 1/8th female- to An male, Right?

 

[kettbo]

They make the stuff hard as Chinese Arithmetic sometimes......

Take your time, do it right..

 

[Dave]

Where is the link to the kit You ordered?