[forcd ind]

my procharged ls (gen 3) 69 project is getting close to comp., about a week or 2 away from a test drive-last hurdle was fitting up the intercooler so it would clear the grill, grill bracket, bumper, and still have enough throw for the hood release handle-i got all that done, now just finishing up minor stuff, brakes, interior, door glass
its not a ss, just used the emblem to fill the 2 holes, its just a 300 sedan, lol

 

[67TurboChevelle]

I can't wait to see how this turns out. Are the plans to race it or a mix of cruise and race?

 

[Camaro_fever68]

Intercooler install looks good. I'm anxious to see how it turns out also.

 

[forcd ind]

like all my crap, its just a street toy, but i will make a pass or 2 just to see how it runs(hence the roll bar and d/s loop)-hope to drive it 164 miles to the Ocean City cruise in 5 weeks, see what parts fall off or i forgot to tighten, lol
lot of work bet now and then, i think i will leave the 3:31's in for now
for those that asked, the color is called Poppy, it is from PPG, hot licks chart-shows more red in photos, put is a deep orange
i wanted to keep the column shifter (bench seat), but the headers interfer with the cross linkage, got the shift works linkage, but wasnt fond of it, might try the lokar setup(not the cable) see how i like it-if not, i'll make my own setup, dub. a belcrank with the orig ratio, but trying to gain some speed on finishing it right now-i talked to lokar about a floor shift, with a bent arm so i could shift it without leaning forward-i never liked a bench seat/floorshift (auto) not a lot of room, unless you have a long arm, lol