[rasanders79]

I was hoping a hole was already precut in the floorboard and was just covered up with something. Unless mine is too dirty to see, it doesn't look like there is anything there. Did any 66 come with a shifter on the floor? Any advice or do you just have to cut away at the pans?

 

[crazychevelle]

You will have to cut a hole unfortunately. If you wanna do it properly you will need a tunnel hump for either with or with out a console. There are a bunch of places that reproduce them for cheap

http://www.ss396.com/mm5/merchant.m.../merchant.mvc?Screen=CTGY&Store_Code=chevellecamino&Category_Code=SHIFTERTUNNEL


Sent from AutoGuide.com Free App

 

[rasanders79]

Will I have to make more cuts if I go with a muncie 4 speed, or will it fit without modifications?

 

[floyd66]

in the link above part number RST-76D is the ONLY correct shift hump for 1966 Chevelle. Bench or bucket seat, 3 or 4 speed. The other shift hump is for GTO, all the vendors keep this error going and going.