[asphaltgambler]

Hi, I did a search here and almost everywhere else, but cannot seem to find this. There is someone repro'ing GM engine / bracket mounting hardware. I am missing the upper rear compressor spacer, bolt and the correct 2 bolts that attach the upper early production style bracket to the intake manifold.

Everything else I have, just cannot find these. Looking to purchase ASAP as this is holding me up. Can be either new or used in good shape. My email: theasphaltgambler@hotmail.com

Thanks!!

 

[Bart42]

Have you tried AMK Products? They make reproduction fasteners.

Linky: http://www.amkproducts.com/GM_Fastener_Kits.asp

I believe they have a $30 minimum order.

 

[asphaltgambler]

D@mn! those guys are 20 miles from me! I do not see the spacer but will call this morning. I thought someone here had posted a similar dealer that had more comprehensive listing of GM fasteners that was out of Florida?

 

[asphaltgambler]

OK so these guys have the bolts but no spacer listed. I need the rear upper spacer between the compressor and the adjust ing bracket.

Anyone here have one??

 

[von]

OK so these guys have the bolts but no spacer listed. I need the rear upper spacer between the compressor and the adjust ing bracket.

Anyone here have one??

I need one too. Classic Muscle shows them in their catalog but no longer carry them. If all else fails I'll fab one.

 

[lrdvdr41]

They are the same as a small block spacer. Shouldn't be that hard to find.

 

[asphaltgambler]

Yes - thanks all! Found it!

 

[von]

Yes - thanks all! Found it!

Where?