Questions on Oil Return Screen Kit

dude67 · Jul 8, 2005

Hello,
I just got my Moroso oil return kit and had a few question. It's for my BBC.

1. Do you cut the ends to fit in the oblong valley? Half circle on each end?

2. Is there enough epoxy? It does not seem like.

Thanks

JIM · Jul 8, 2005

I used the Moroso kit as well. Didn't look like enough epoxy in those little tubes, but there was. I did not cut the screens at all, just layed them in there and gooped them in place. Look.....
Here they are baking/drying...

Here they are after the block coating...

Bob West · Jul 8, 2005

I still like that pic Jim, looks like "Fire in the Hole"

Quit working so hard and get that thing finished!!!

JIM · Jul 8, 2005

I hear ya Bob....Only thing is that I am 240 miles from home again. Working in Virginia,,,,,block is back home in PA.

phel69 · Jul 9, 2005

My kit came from Home Depot

. Storm door Screen, JB Weld and some flat, round magnets for the lifter valley and heads. I think it ran about $5.00.

Questions on Oil Return Screen Kit

Top Contributors this Month

Recommended Communities