Team Chevelle banner
1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Is it worth the time and effort to pull apart and port match the heads to the intake in the pic? One side of the port on all 8 is off about 3/16 max. Or is this not a big deal.
Liquid Eye Water Automotive tire Eyelash

Automotive lighting Hood Grille Motor vehicle Vehicle
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #4 ·
A lip in a wet flow deal can sometimes be beneficial.
Look at the mismatch of the BBC square port intake on oval port heads.
It flat works.
The true and only way to know if it would be better to port match it will be to run it as is then port match it and retest.

Yea not what you wanted to hear.
Crap, so much easier to port the intake. That’s just a mock-up so it won’t be as bad. I did scribe and mark it just in case while it was assembled.
 
1 - 6 of 6 Posts
Top