Chevelles.com banner

1 - 2 of 2 Posts

·
Registered
Joined
·
500 Posts
Discussion Starter #1
I've been following the instructions on how to get rid of my voltage regulator as shown here , but I need to know what terminals on a Powermaster alternator are #1 and #2. They aren't marked, and my instruction manual with the alternator does not say.
 

·
Registered
Joined
·
507 Posts
I just hooked up a 200 amp powermaster. I had a plug with mine with a yellow and a red wire. I put a 47 ohm resistor in series with 12v wire when in run to the yellow wire and that was it, cept for the your charge lead which goes on the large terminal. If you have more ? on powermaster you always email them at:

[email protected]

I did and they got back to me in less than an hour.
 
1 - 2 of 2 Posts
Top