Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I'm going to replace the wiring and fuse box in my '65 300 Deluxe. The original is shot and due to engine swap and component adders, I prefer not to use stock replacements.

I'm considering a Painless or American Wire wiring kit. Can someone comment on selection, completeness and installation.

Thank you - David
 

·
Premium Member
Joined
·
307 Posts
David,
I haven't installed my Dash Harness yet for my 65, but I did put in the M&H Rear Harness from Ground Up and it was a perfect fit. All connections were factory original and it fit like a glove. Hoping my dash harness will be just as good. Just my $.02.
John
1965 Danube Blue Malibu
 

·
Registered
Joined
·
11,941 Posts
M&H is the way to go, www.wiringharness.com they will do some custom work if you ask.

------------------
Leo Paugh
Maryland Chevelle Club #017
A.C.E.S.#3731
progress has little to do with speed, but lots to do with direction.
Maryland Chevelle Club
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top