[ChevJerico]

Any suggestions? Already have the valve covers, but could change for something else. They do have built in baffles and I like that part. The only thing I found searching the archives is a Moroso part turned upside down in this thread by Bracetchev1221

Plug Wire Looms & Fabricated Valve Covers

Need a clean looking solution for Plug Wire Looms that work well with fabricated Valve Covers. What are you guys using?

www.chevelles.com

 

[Nasty-Z]

Answered the wrong thread , anyways :

I used a piece of 1" aluminum and fastened the Moroso BBC wire looms to it , still not really a fan of the setup , but it works for now .

-TOM

 

[sz0k30]

What does "valve covers without rails" mean? OK - I see.

 

[ChevJerico]

Answered the wrong thread , anyways :

I used a piece of 1" aluminum and fastened the Moroso BBC wire looms to it , still not really a fan of the setup , but it works for now .

-TOM

That's not a bad idea.

 

[bracketchev1221]

Any suggestions? Already have the valve covers, but could change for something else. They do have built in baffles and I like that part. The only thing I found searching the archives is a Moroso part turned upside down in this thread by Bracetchev1221

Plug Wire Looms & Fabricated Valve Covers

Need a clean looking solution for Plug Wire Looms that work well with fabricated Valve Covers. What are you guys using?

www.chevelles.com

Yup, that was the best thing I came up with. Worked great until I sold the car in 2018. Everyone asked me where I got that set up from!!!

 

[ChevJerico]

Yup, that was the best thing I came up with. Worked great until I sold the car in 2018. Everyone asked me where I got that set up from!!!

Cool, I do have super looms on my small block, but I noticed it's a different part for BB. Did you go with the regular or super looms if you remember?

 

[bracketchev1221]

I think it was part 72176.

 

[ChevJerico]

I think it was part 72176.

Cool, thanks!