Team Chevelle banner

Wiper motor started smoking!

5528 Views 7 Replies 6 Participants Last post by  ASB
This is a good one. I replaced my wiper motor which has never worked since i got the car. I had tried jumping the terminals to see if the old motor was any good, but i never got it to work. So I bought a new motor, removed the washer pump from the old motor and bolted the thing back in. Fast forward to today when i hooked up my battery for the first time, the wiper motor made a little whir or click and started smoking! :eek: Well naturally i pulled the wires off and re-checked that i had them hooked up right per the diagram from this site. I disconnected the wiper arm thinking it may be binding or something but no deal, it just starts smoking again. I think I may have toasted it. What could cause this?? could i have put the washer pump on wrong?? THanks
Steve
1 - 3 of 8 Posts
I took the thing apart to see where the smoke was coming from and the smoke was coming from a resistor in the back of the wire connector. From what I could see, a large glob of solder made contact with the motor body and melted the end off the connector. I hope NAPA takes it back as I bought it in Sept. but had the motor out of the car till last week.
Thanks for the replys, I did return the motor and will check everything thoroughly before putting the juice to this one!
Steve
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top