[boduke]

today i just took apart my wiper motor, completely cleaned the entire thing-had like an inch of grease on it. anyways, it has 3 connections coming somewhere out of the middle, and two connections coming out of the black plastice peice. could someone please post a diagram of what these do, and where they go into the fuse box, thanks

------------------
70 El Camino SS 396
3.73 with a 12 bolt

have pics taken, but just need to upload them somewhere.....

 

[John_Muha]

Take a look at this. It's close. Wiper motors are ground switched. http://www.chevelles.com/forum/Forum22/HTML/000734.html

 

[boduke]

ok, that helped a lot for the actual wiring, but im not sure where its supposed to go into the fuse box?

 

[John_Muha]

Power runs through the bulkhead connector and into the fuse block. From memory, there is a wire goes between the wiper connector and the pump connector. It has yellow on it, something like a black/blue/yellow wire. This is the power line. After it exits the inside bulkhead connector it goes straight into the fuse block. Wire is yellow between the bulkhead connector and fuse block.

 

[boduke]

ok, none of the original wiring is on it, so im guessing that just any old 12 gauge wiring will work?

------------------
70 El Camino SS 396
3.73 with a 12 bolt

have pics taken, but just need to upload them somewhere.....

 

[John_Muha]

<BLOCKQUOTE>quote:</font><HR>Originally posted by boduke:
ok, none of the original wiring is on it, so im guessing that just any old 12 gauge wiring will work?

<HR></BLOCKQUOTE>
What are you trying to do with the wiper? Make it work outside of the car? It needs a solid ground through the mounting eyelets. 12 gauge is fine. I'd get a connector for the pump from a junkyard harness if you are trying to power it up.