I used a 4X4 under the top of the quarters supported by some other lumber. I used that same 4X4 with an engine hoist to pick up the back of the car to remove and reinstall the trunk floor. Good luck.
Where to support car when removing trunk pan
Where should I support the back of the car when removing the trunk pan? Jack stands under the quarter lip/wheel house? Stick the rotisserie arms through the tail light holes in the tail panel? I know the car should be on the frame, but I’m trying to figure out the best way to hold everything up while I cut the trunk pan out.
1 - 1 of 2 Posts
1 - 1 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
