Where can I connect the hot wire on my electric choke?

2714 Views 10 Replies 6 Participants Last post by Check6, Mar 1, 2007

Check6

Discussion Starter · Feb 28, 2007

I'm installing a new carb with electric choke. Directions say to connect the hot wire to a keyed 12 volt source. Must be 12 volts all the time with the key on. Any ideas where I can tap in? This is a 396 engine.
Thanks,
Fred

Save

1 - 1 of 11 Posts

Elree Colby

· #10 · Mar 1, 2007

Black with yellow stripe.

Save

1 - 1 of 11 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.