Team Chevelle banner

Where can I connect the hot wire on my electric choke?

2673 Views 10 Replies 6 Participants Last post by  Check6
I'm installing a new carb with electric choke. Directions say to connect the hot wire to a keyed 12 volt source. Must be 12 volts all the time with the key on. Any ideas where I can tap in? This is a 396 engine.
1 - 1 of 11 Posts
I'm bad... I just tapped my choke into the HEI power feed because it was the closest. It seems to work fine.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.