Team Chevelle banner

Wheel wells, but not quarter?

617 Views 2 Replies 2 Participants Last post by  baloo28
I have been working feverishly on the passenger quarter, wells, and trunk and am almost done. I looked over the driver quarter, and even though I ordered a new one, it seems as if I can get by without replacing the quarter. The wells are another story. Anybody have any ideas as to replacing the wells and not the quarter? I can do the whole thing, but if I can get by with only the wells, it would be great!

Any advice would be appreciated.

1 - 1 of 3 Posts
one of the most difficult sheet metal replacements with the quarters on. just drill out the spot welds and you should be able to fit it in there. its a b#$% to do but it can be done.
if u replace the quarter u will have a very very easy job compared too :)
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.