Team Chevelle banner
Cancel

Wheel Hop

998 Views 6 Replies 6 Participants Last post by  Bomber '67, 
C
Am going back together with my car that has been apart for years. When I was driving it , I remember the thing I HATED WORST was when I wanted to "burn out" from a dead stop the rear end would bounce very badly, What can I do to eliminate this and retain as much origonality as possible. Obvious modifications such as ladder bars are not an option. THANKS!!!
Reply
Save
Like
1 - 1 of 7 Posts
S
Or, if you already have boxed arms, you could just make four metal plates, to drop your arms a few inches like the SSM bars do. I saw a posting for a 10 bolt that did exactly this. It eliminated the wheel hop, so that article stated. You would have to make sure that your pinion angle was correct.
Does anyone know why this setup would not work, or why it would be a bad idea?

Thanks,
Fred.
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top