What's needed to get the Cowl outer door functioning

829 Views 4 Replies 3 Participants Last post by Ryan_K, Jul 9, 2013

Ryan_K

Discussion Starter · Jul 9, 2013

I'm looking to get a cowl hood for my '72, I don't care about the inner door at all as I'm just looking to get clearance for a small blower. Is this all I need to get the outer door working? Also where does the vacuum line get connected for it to function properly.

http://www.ss396.com/mm5/merchant.mvc?Screen=PROD&Store_Code=chevellecamino&Product_Code=ACX-970

Thanks!

Save

1 - 3 of 5 Posts

Ryan_K

Discussion Starter · #3 · Jul 9, 2013

Thanks! Those posts look to have the info I need, I'm not too concerned about it functioning all that well, that looks like it'll be a lot of trial and error, I just wanna make sure I have all the correct parts to play with, should be good according to those posts.

Save

Ryan_K

Discussion Starter · #5 · Jul 9, 2013

I'm well aware of that, I actually prefer the look of a stock flat hood. The only reason I'm switching is to fit a blown 383 under there and I find the cowl induction hood without the flapper door to be too plain and don't like any of the aftermarket scoops on the '70-'72s.

Save

1 - 3 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month