Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Premium Member
Joined
·
1,496 Posts
Hi I have pictured below the Gauge setup for a 1966 Chevelle I purchased from the Parts Place , my question is the temp gauge after installing always reads hotter then the actual mechanical temp gauge I also have installed. I am looking to install a resister to the temp gauge from the nail head sensor to lower / adjust it to the proper reading as my mechanical gauge reads 180 View attachment 742662 View attachment 742659 View attachment 742658 View attachment 742658
I had the same problem and installed a resistor. It was reading too hot, now it's good.

Was looking, can't find it. I did use info from googling temp sensor ohms, something like that. Once you figure out the ohms required, you can size a resistor.
 
1 - 1 of 1 Posts
Top