Team Chevelle banner

What drive shaft to use??

652 Views 2 Replies 3 Participants Last post by  Robinls5
I just picked up a driveshaft for my 700r-4 conversion.
I believe it was for a smallblock car, because there is no tapper on one end and has a 350 yoke on it.
My question is, will this DS be ok with a bigblock?
1 - 1 of 3 Posts
Yes it will be fine. I have my stock driveshaft in my Chevelle, and I am running a 427 around 500 hp, running high 11's in the 1/4 mile, and its fine.

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.