Team Chevelle banner
Cancel

What drive shaft to use??

653 Views 2 Replies 3 Participants Last post by  Robinls5, 
Brian L34
I just picked up a driveshaft for my 700r-4 conversion.
I believe it was for a smallblock car, because there is no tapper on one end and has a 350 yoke on it.
My question is, will this DS be ok with a bigblock?
Reply
Save
Like
1 - 1 of 3 Posts
R
I started with a 307- and a ten bolt in my Sta. Wgn. Now 468 B.B. 700R4---12 bolt rear and the 307 drive shaft. The 307 driveshaft has been behind a 396-454-and now a 468.
The 700R4 and the 307 D-Shaft have been working fine since 2002 ! Dont worry Be happy !
Bob
Reply
Save
Like
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top