The kit is made by Evertough from oreilys.
Using a thread chaser on an Iron head
Rectangular port 188's on a 454. The heads are on the block. I'm concerned about crud and maybe a some metal shavings where they might end up (I am using a true thread chaser kit, not a tap, but I still think some metal may be cut out with the chaser). I see that some of the holes have passages past the threads. I can use grease on the thread chaser but wonder if I'm doing more harm than good. So should I chase the threads in the head or leave them be?
1 - 4 of 9 Posts
crud
Got all the thread sealer out. Time to Gasgacinch the gaskets. As always I appreciate the help. As another member mentioned in his thread "Team Chevelle is the best tool in his toolbox" and I agree :yes:
1 - 4 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
