Team Chevelle banner
Status
Not open for further replies.

upper control arm shafts

1K views 5 replies 4 participants last post by  Tom Mobley 
jaqazi

options:
1) take it to frame shop and have it fixed, no big deal here.

2) have them set the toe and run it, if it doesn't pull you're OK, they can probably fix the caster if they feel like it.

3) put the shafts in, I've seen a couple that were bad enough that the shafts didn't completely fix the problem.

If you don't know a good frame shop here in the Valley email me and I'll get you a name.

Tom
 
jaqazi

>>Should they have done this?

Probably not unless it was a Chevelle-only shop.

>>Would I have to repaint a lot of stuff? Can they do it with the dog
house on the car?
You might have to do some touchup but I don't think this is a big deal for a good shop.

>>Would
too much negative caster cause this? The car drives fine otherwise.
Yes.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top