Team Chevelle banner
1 - 3 of 3 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter · #1 ·
Could someone post a picture of where the steel vacuum line runs on a turbo 400 for a 68 chevelle. I just put a rebuilt Turbo 400 in my 68 SS 396 and would like to make sure that the line is run the right way. It looks correct the way I have it, but would like to make sure. Also, did they run that off of the manifold, or off the carberator?

Thanks
HovsSS
 

·
Registered
Joined
·
121 Posts
I have a TH400 in my 70 ( I would think 68 would be the same) and the line goes to a fitting in the manifold behind the carb and in front of the dist.

MrBreez
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top