Team Chevelle banner

Trunk extension problem

875 Views 6 Replies 5 Participants Last post by  Blownchevelle68
I picked up a 70 Chevelle that the person before me installed a new quarter and trunk floor. Strange thing is, on the side where they installed the new quarter, they never put in the trunk floor extension that attaches to the quarter and trunk floor. So now when you open the trunk, you can look in the corner right to the ground. The quarter also moves a little because there is no support.

Im going to have this fixed at a body shop, but for now want to secure the quarter. What kind of metal would be best to fab up for this? Can I just cut something out and temporarily attach it, using a sealer of some sort that will come out without damaging the quarter or trunk floor.

I dont want to leave this the way it is, because Im afraid it will damage the quarter over time. Not to mention it's throwing rocks and other crud inside the trunk. I can try and get a pic if this helps...Thanks, Jason
1 - 3 of 7 Posts
Would a seam sealer work for temporarily holding the extension in, until I can have it welded in? I don't want to weld in just yet because the body shop said it will damage the paint. Since I have other body work needed within a year, I'd rather wait until then to weld in, that way I don't have to paint the quarter twice...
What brand of panel ahesive? 3m or what would be best ..? I suppose I could use something below the car to hold the panel up while I usedthe adhesive
1 - 3 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top