Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter · #1 ·
I need to know what size the 2 bolts are that hold the bracket on the transmision that supports the floor shift cable. I don't seem to have the right size in my bolt bin. Trans is a TH350 in a 71 malibu.
 

·
Registered
Joined
·
336 Posts
You use the same thread size that the pan bolts are, I got my bracket from the junkyard and the two bolts did have regular cap screw heads, the regular pan bolts have the large head with "washers" built in

------------------
Frank W
Gen X Member#22 (MA)
73 Malibu Coupe
http://hometown.aol.com/folingo/myhomepage/auto.html
Mighty 305 Power
 

·
Registered
Joined
·
227 Posts
Discussion Starter · #3 ·
73Malibu, that would make sense. Thanks

I had a 1/4 bolt that was to small...so I tried a 5/16 bolt but it was to big.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top