Team Chevelle banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,177 Posts
You are correct. The gear has been machined and no bearing. The bearing from Comp looks to be correct, or what has come on sets I have used. Call and see if the manufacturer will send you a bearing. That gear has to have a bearing and the bearing should sit slightly higher than the machined lip.
 

·
Registered
Joined
·
1,177 Posts
I have bought 8 Rollmaster gold sets the last 3 years off Amazon. All were exactly as advertised and fit perfectly. Ebay is another story.

I have one left in stock. Reading off the box it says: P/N CS2040 Chev BB Torrington bearing set std. , Both sprockets nitrited, IWIS pro series chain. This is still sealed in the box. Same as all the others I bought. All worked fine with as much as 350 seat pressure and over 900 open valve spring pressure.
 
1 - 3 of 3 Posts
Top