Team Chevelle banner

throwout bearing

839 Views 4 Replies 3 Participants Last post by  juggie1
I have a 1967 chevelle, and i'm having problem with getting slack in the fork to throw out bearing, I thing I install the bearing wrong in the fork, I slide the end into the spring, and someone told me that It just between the were the spring rest on the back of the bearing instade of hooking in the sring ,can anyone show a diagram of It, It a four speed muncie thanks In advance
1 - 3 of 5 Posts
EddieC67ss said:
Did you change bellhousings? If so there are 2 different size piviot balls. The chevelles take the longer one.
Yes I change the bellhousing I went to an 11" clutch, hays clutch pressure plate, and throut bearing,It has a big block in it, so what u are saying Is the spring connect to the rear of the bearing, Thanks again.
thanks for that advise,I'm in the process of putting the car back togather, how do you get the pic to post i join cardomain, and i just can't figure out how to post my pic. i had my nephew do it for me but I can't get intouch with him, so If u can explain I would appreciate It. Thanks again
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.