I don't think the heads have been milled, but I don't know about the block(I'm not the original builder of this engine, I just get all the guesswork). How do I measure the intake to determine how much to mill it?
Spoileddaddy
Spoileddaddy
"Thin Intake Manifold Gaskets"? Do they exist?
I have Pro Heads and an Edelbrock Victor Jr. Intake on a SBC 400. I was wondering if they make "thinner" intake gaskets than what Fel-Pro offers as standard size(thickness). Simply because, when I test fit the intake on the block without gaskets, the holes line up perfectly. With gaskets, not so good. I am hoping someone can help me(you folks haven't failed me yet!). I appreciate any help or suggestions. P.S.- The heads are torqued down, if that helps......
Spoileddaddy
Spoileddaddy
1 - 2 of 7 Posts
1 - 2 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
