Team Chevelle banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter #1

·
Registered
Joined
·
63 Posts
Discussion Starter #3
the dash is plate aluminum. about 1/8" inch thick. the riser for the tach is made of the same stuff. very rigid and very hard to cut holes in. I decided that the blower motor had eaten its last fuse and the heater was starting to smell sweet, so it all came out. I wanted something that followed the base of the windshield for curvature. I just coerced the aluminum into position and cut in the gauges.

------------------
1BADS72
Robert Anderson
pages.hotbot.com/photo/1bads72/
[email protected]
THE HAPPY LITTLE TYR FRYR




[This message has been edited by 1BADS72 (edited 10-01-99).]
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top