Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part May's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
552 Posts
Discussion Starter · #1 ·
Well, I just went out and bought a brand new switch from muscle factory, and hooked it up and everything, and it still seems to be on when the switch is off. I found out just by hearing the motor, you can here the washer pump in the "off" position w/ the motor on w/ it, and when you switch it to 1st and 2nd speed, the washer turns off and the motor goes to either its 1st and 2nd speed. Now what could it be? thanks. Eric
 

·
Registered
Joined
·
552 Posts
Discussion Starter · #2 ·
FINALLY, I think I finally found the problem. Thanks to John_Muha, he helped solve my problem by hooking up a 12 volt source up from the alternator to just the motor itself w/out the harness being connected, and the motor still turned.

Elree Cobly, I think you were right about what's going on inside the motor about the switch inside not opening and opening maybe due to vibration. Sorry, Elree, I didn't doubt you or nothing, but I was able to turn it off when I gave the switch a little tug once or twice. I might just keep that new switch I just bought after all.

I'm going to email WiperWorks right away and see if I need to send it back. Thanks John and Elree, helped me out alot. I love this board. Eric
 
1 - 2 of 2 Posts
Top