Team Chevelle banner

Starter brace for SB PMG260 style high torque

600 Views 5 Replies 3 Participants Last post by  Jim_66SS
Do you use the original SB brace that was used on those heavy Delco starters? Like for the Remy RS41117
1 - 1 of 6 Posts
Cheap insurance, run the brace on all starters, large and small diameter. On those without a stud to mount the brace,I take the rear end off the starter, drill and tap the end cover for a duuble ended hex stud frm my local hardware store, reassemble, add the brace. DIRT SIMPLE, COST IS ALMOST NIL, strangth is leaps and bounds better.
  • Like
Reactions: 2
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.