Team Chevelle banner
Cancel

Spot Face Bit

4185 Views 6 Replies 4 Participants Last post by  von, 
V
Anyone know where I can get an economical 1/2" spot face bit? Need it to spot face gasket surfaces for the needle seat of Q jet carbs (soft metal).
Reply
Save
Like
1 - 1 of 7 Posts
B
Von,
What size would the pilot diameter need to be? Spot face cutters (also known as counterbores) use a pilot stub in the hole in order to cut a true face. See tool on far right in pic below.
I can make one up when I return to work. Also, any radius on the edge of the spot face? Often there is...
See less See more
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top