Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part May's Ride of the Month Challenge!

1 - 6 of 6 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
Need a leed ? just installed a set of SS stock gauges in my 69 elky.
What I would like to do is run the stock temp & oil gauges along with my under dash Autometer temp & oil and run both from stock sender units o
[email protected] .r r.con
 

·
Registered
Joined
·
68 Posts
Discussion Starter · #3 ·
I just need the manufactuter of a temp gauge that well work with the stock chevy sender for 69 SS gauge package. also the same deal a manufacturer that make a oil gauge that can work with a 69 oil pressure sender. The if available will let me run both my dash gauges and my under dash oil,amp,temp (you know the accurite ones.

help me
 

·
Registered
Joined
·
7,762 Posts
I keep reading that you want to run 2 gages off the same sender. Won't work that way. You will need a sender for each gage and a separate wire run to each gage.
 

·
Registered
Joined
·
532 Posts
If yu find the gauge and or senders to do this, I think you can do it with a SPDT switch, but without a switch its like John_Muha said "Won't work that way"

With the switch, your input from the sender can be directed to either gauge, depending on switch position or vice versa.
 

·
Registered
Joined
·
532 Posts
Forgot to mention, there is a member that only uses 1 gauge to monitor his engine water temp and tranny fluid temp, by using a switch and 2 senders.
 
1 - 6 of 6 Posts
Top