[Kopfjaeger]

I’m looking for a method to secure my Techflex split loom in tight areas like the upper channel my 67 Radiator support. I know the factory had plastic posts taped into the loom at certain points to secure into holes in sheet metal. See attached photo. While I suppose I could weave in a few on my Techflex, the plastic is 50+ Years old and quite brittle. Plus there has to be something better that is more compatible with the Techflex, right?

Joe

 

[SSJohn]

I used small black nylon p clamps with stainless hardware, heads to the outside. Worked out pretty good. You can see the heads on the upper part of the rad support I got the clamps from the same place I got the loom, so everything fit really well

 

[The Geologist]

See about getting some push-in zip tie cable mounts. Your local hardware store would probably have them.