Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
I just removed the stainless steel roof rail pieces from 67 Malibu and I am about to re-intsll them, however, the book (Fisher Body Manual) says to use a "pumpable" caulk to attach roof rails to roof. They are also attached by some 12 screws. My problem is, is what is a "pumpable" caulk? What came off was something like a foam tape with what appears to be some soft grey compound. It came off easy enough, and if I were to replace weatherstripping sometime in the future, I would certainly like it to come off easy again. Any ideas out there?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top