Team Chevelle banner
Cancel

roller cams and mech fuel pumps

1042 Views 4 Replies 5 Participants Last post by  BowtieAaron, 
F
some time ago i had used a hyd roller (cast iron) and a mech fuel pump-i had to replace the cam when the pump lobe went flat-im getting ready to build a BB with a roller and mech pump, and now wondering if it was the same deal with flat tappet lifters and modern oils-lack of zink or whatever
i realize the pump doesnt have as much pressure as a valve spring/lifter on the cam, but wondering if it does create a problem, and should you use an additive like what they use for flat tappet cams
i know on billit cam cores they have the bronze tipped pushrod, and even a roller tipped one
any thoughts on this(and no i dont want an elect pump, lol)
Reply
Save
Like
1 - 1 of 5 Posts
B
LS7 said:
Billet cam, bronze tip push-rod here, no special oil or additives, just plain old Castrol 10W30. :boring:

No roller tip fuel pump push-rod for a big block Chevy that I am aware of, is there? :confused:
Click to expand...
thats what i have. and its in an 880 96+ vortec truck block, and didnt take any mods to run.
voodoo hyd roller cam too, and holley 130gph mech pump

aaron
Reply
Save
Like
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Bench Racing Performance Engine Body Shop Chevelle Tech
Top