Team Chevelle banner

rocker ratio/guide wear

800 Views 4 Replies 4 Participants Last post by  steelcomp
lets say your s/b has the 1.5 fact. ratio rockers, correct p/r length, and you install 1.6 rockers, correct p/r length-is their gonna be more wear on the guides than the 1.5, enough to cause a problem-the lower ratio would roll back and forth from the center of the valve less than a higher ratio, so it would be pushing more on the center area, rather than farther out
i assume the fact. designed them with long life in mind-so i guess the question is, is the small gain in lift worth any possible wear
1 - 1 of 5 Posts
Re: rocker ratio/guide ware

I will say that from what I read, the difference will be very nominal. Possibly even unnoticeable unless you are comparing time slips down to the tenth or hundredth of a second.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.