Replacement Procedures.

922 Views 5 Replies 5 Participants Last post by 'clees, Dec 9, 2005

LateNight72

Discussion Starter · Dec 7, 2005

For all those more "experienced" body techs.. Would you mind reviewing my plan of action... TIA

1. Adjust Decklid/Door to proper spec
2. Replace Rear Seat Pan
3. Replace Floors
4. Replace Deck Filler Panel
5. Patch RH Quarter
6. Remove LH 1/4
7. Remove outer/inner wells
8. Position both wells to fit
9. Position 1/4 to proper fit.
10. Remove 1/4, weld in Wells.
11. Weld on 1/4

The positioning would use sheet metal screws so I would have a guide to go about when put the 1/4 back on..

Thanks,
Todd

Save

1 - 1 of 6 Posts

RUQKENF

· #2 · Dec 8, 2005

I am not a bodyman by any means, but I did just do quaters on my 69. I also replaced the outer wells, inners were good. Keeping the inners also made it easier to postion the outers. I would use rivets instead or sheetmetal screws because the screws will want to pull the metal around the hole and distort it.
Tony

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month