Replacement Procedures.

918 Views 5 Replies 5 Participants Last post by 'clees, Dec 9, 2005

LateNight72

Discussion Starter · Dec 7, 2005

For all those more "experienced" body techs.. Would you mind reviewing my plan of action... TIA

1. Adjust Decklid/Door to proper spec
2. Replace Rear Seat Pan
3. Replace Floors
4. Replace Deck Filler Panel
5. Patch RH Quarter
6. Remove LH 1/4
7. Remove outer/inner wells
8. Position both wells to fit
9. Position 1/4 to proper fit.
10. Remove 1/4, weld in Wells.
11. Weld on 1/4

The positioning would use sheet metal screws so I would have a guide to go about when put the 1/4 back on..

Thanks,
Todd

Save

1 - 1 of 6 Posts

snowtrav

· #5 · Dec 9, 2005

LateNight72 said:
For all those more "experienced" body techs.. Would you mind reviewing my plan of action... TIA

1. Adjust Decklid/Door to proper spec
2. Replace Rear Seat Pan
3. Replace Floors
4. Replace Deck Filler Panel
5. Patch RH Quarter
6. Remove LH 1/4
7. Remove outer/inner wells
8. Position both wells to fit
9. Position 1/4 to proper fit.
10. Remove 1/4, weld in Wells.
11. Weld on 1/4

The positioning would use sheet metal screws so I would have a guide to go about when put the 1/4 back on..

Thanks,
Todd

I did one well at a time so i could reference the other for aligment,as for the holding the panels to position i used the welding clamps,you can easily adjust different areas of the panel at any time then i spot welded and double checked the alignment before final welding. Alan

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month