Team Chevelle banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I picked up a 400 SB for free that hadnt been running for a long time so I took all the pistons out, removed the heads, everything except the crank and cam. How does the harmonic balancer come out. Is there a pin that needs to be removed? I can see a groove. THanks for any help!!
DJ
 

·
In Memoriam
66 El Camino 57 Chevy pickup 2004 Tahoe
Joined
·
27,862 Posts
DJ,

The damper is pressed on. To remove it you use a puller tool similar to a steering wheel puller but heavier-duty. DO NOT use a puller that grabs onto the outside diameter, this will just ruin the balancer. The puller uses the 3 fine-thread holes that the pulley bolts on with.

When you re-install the balancer, a tool is used to push it on. If you use a hammer, the balancer is ruined.

Tom
 

·
Registered
Joined
·
13,605 Posts
Good grief! Some guys have all the luck. A friend of mine was just GIVEN 2 '62 Bubble Tops because the guy lost his storage space.

------------------
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top