Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Could someone tell me how to wire a remote solenoid into my ignition which has an HEI distributor? Also, what guage wire should be used to wire it? Also, what would cause my GEN light to stay on while engine is running? Got new starter and battery. Had ALT checked and working fine. When ign key is turned to ON position, no dash idiot lights lite up at all. Also installed new neutral safety switch at bottom of steering column. What else could it be?
 

·
Registered
Joined
·
341 Posts
The HEI doesn't draw a huge amount of current so a number 14 wire should handle it. No relay required, the ignition switch is a pretty healthy piece. Sounds like you need to get a wiring diagram and get into the wiring pretty deep to get the idiot lights straightened out. Could be an open ground somewhere. tom
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top