Team Chevelle banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
I replaced my bolt rear with a 12 bolt, which was pretty straight foward. The old shaft is the correct length,so that was a good thing. It looks like the rear joint (pinion side) is a hair too short. I have approx 1/16 of an inch side to side play. Not in the caps. Is there a different joint for a 12 bolt vrs a 10 bolt ? Thanks for any info
 

·
Premium Member
Joined
·
9,796 Posts
You may need to look at U-joints with unequal lengths across the bearings. That is, one part of the joint will fit your shaft and the other (longer) part will match the pinion flange.
 

·
Registered
Joined
·
150 Posts
The joint that JWagner is referring to is called a conversion joint and is available through Spicer. The part # is 5-3022X.
 

·
Registered
Joined
·
20 Posts
Discussion Starter #4
Thank you very much for your help !!!!!!!!!!!!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top