Team Chevelle banner

rear trailing arm pictures

2120 Views 5 Replies 4 Participants Last post by  HKalin
Does anyone have pictures of the boxed arm orientation? I am trying to figure out they way the bushing flange should face. I am looking at my arms and it looks like they both face the same way. Is this correct? I did a search but I can't find any pictures. Thanks
1 - 2 of 6 Posts
There are no lefts and rights on either the upper or lower rear control arms.


See less See more
Thanks for the responses! I am just worried about the "lip" that sticks out of the arm from bushing hole. Does it act as a spacer? Can I just install the arms with both facing same side of the vehicle?
Like I said there are no rights or lefts on the rear control arms. In the picture I posted they are shown on the bench just like they would be mounted to the car looking from the back and if they are drilled for a sway bar the holes will be on the end where they mount to the axle.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.