[Big Dre 72]

Does anyone have pictures of the boxed arm orientation? I am trying to figure out they way the bushing flange should face. I am looking at my arms and it looks like they both face the same way. Is this correct? I did a search but I can't find any pictures. Thanks

 

[HKalin]

There are no lefts and rights on either the upper or lower rear control arms.

 

[Hiline51]

If they are drilled and bushed for a sway bar, that end goes to the rear (F41)

 

[Big Dre 72]

Thanks for the responses! I am just worried about the "lip" that sticks out of the arm from bushing hole. Does it act as a spacer? Can I just install the arms with both facing same side of the vehicle?

 

[Finally]

Don't worry about it, the sleeve in the center of the bushing keeps it centered.

 

[HKalin]

Thanks for the responses! I am just worried about the "lip" that sticks out of the arm from bushing hole. Does it act as a spacer? Can I just install the arms with both facing same side of the vehicle?

Like I said there are no rights or lefts on the rear control arms. In the picture I posted they are shown on the bench just like they would be mounted to the car looking from the back and if they are drilled for a sway bar the holes will be on the end where they mount to the axle.