Team Chevelle banner
1 - 3 of 3 Posts

· Registered
39 Posts
Discussion Starter · #1 ·
I put a Moser 12 bolt posi in a 65 Chevelle 300.
The Moser had no mounting pads for the axle bumpers.
I am assuming I need the bumpers to prevent axle slamming into frame.
I do not have the original 10 bolt axle housing anymore.
Anyone have any suggestions?

I figure I'll have to find an old housing, torch the mounting pads off, and reweld them to the Moser unit.
Is there an easier way?


65 Chevelle frame-off rebuild.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.