pre-fabbed Sheetmetal for trans tunnel?
Getting ready to do the major hack/slice to fit the T-56 into my 70 here. Wondering what's the best way to approach the reconfiguration of the trans tunnel in the floor for it?
I know I'm going to have to raise the tunnel about 2" to make room for it. So I was kind of thinking about just cutting it down low, all the way around, raising it and welding material in to fill the void areas.
That way I'd also keep the original tunnel contours/shape so (maybe) I could still run a console.?
But then again, seeing as I'm probably not really going to be running a center console, and in the interest of making life easier I was wondering if anyone sells a pre-fabbed tranny hump/tunnel that I could just weld in over the hole and be done with it?
Also can anyone running a T-56 tell me how your carpet fits after doing the necessary floor surgery?
I know I'm going to have to raise the tunnel about 2" to make room for it. So I was kind of thinking about just cutting it down low, all the way around, raising it and welding material in to fill the void areas.
That way I'd also keep the original tunnel contours/shape so (maybe) I could still run a console.?
But then again, seeing as I'm probably not really going to be running a center console, and in the interest of making life easier I was wondering if anyone sells a pre-fabbed tranny hump/tunnel that I could just weld in over the hole and be done with it?
Also can anyone running a T-56 tell me how your carpet fits after doing the necessary floor surgery?
1 - 1 of 2 Posts
1 - 1 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Team Chevelle
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
