Team Chevelle banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,964 Posts
Nailers can use ANY air compressor, however, your DA on the other hand needs A LOT of CFM. I think the one you are looking at will have problems running a DA. On average you should have a compressor that can deliver around 11-13 SCFM @ 90# to run a DA. Framing nailers run on 2.2 SCFM and a 1/2" Impact wrench as well as a cut off wheel needs some where around 4-5 SCFM @90#.
 
1 - 1 of 1 Posts
Top