Team Chevelle banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
403 Posts
Discussion Starter #1
I need to replace trans mount. I already have new motormounts installed.

Do you have a poly trans mount??

Do you think it is a good idea to mix regular engine mounts with a poly trans mount?? Why or why not?

------------------
Mr. D
72 454 El Camino
68 RS/SS Camaro
73 RS/LT/Z28 Camaro
99 Firebird TA WS-6 A4
 

·
Registered
Joined
·
994 Posts
Yes - I installed both motor & trany mounts with poly ones. The trany mount will cause motor mnts to fail. Some guys will replace the trany and driver side mounts with poly mounts. The pass side is always under "Compression" during accelaration, therefor the only time it goes bad is when the others fail.

------------------
Lowered '67 Elcamino
ZZ430 eng / 4L60E trans
"Canyon Carver"
 

·
Registered
Joined
·
167 Posts
I too have the poly mounts at all three points. Very happy with them. As for mixing them, I don't know.
 

·
Registered
Joined
·
9 Posts
Is anyone making a poly big block mount for a 70. I ordered one several months back but was sent small block mounts. My other question is, will the poly mount effect header clearence?
 

·
Registered
Joined
·
326 Posts
I have Energy Suspension mounts in my car. They all have that extra flat piece of steel that comes with it. What is the purpose of this thing, and what happens if I take it out?

just wondering

Dave
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top