Chevelles.com banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter #1
Has anyone used (or known someone who has)Painless Wiring's 69-72 GM MuscleCar wiring harness ??? My dash harness is cherry and I have factory tach/gauges.I would spend about what a painless harness would cost on engine/front light/intermediate/trunk harnesses.Does anyone know if the painless harness would work on the factory tach/gauge package ??? Thanks Everyone.Shawn (also not concerned with 100% factory correct for 69SS Here)

------------------
 

·
Registered
Joined
·
330 Posts
Painless' stock replacement harnesses are made by M & H Electrical Fabricators, Santa Fe Springs, Ca. Painless does make their own hot rod from-scratch looms for street rods, but not the stock replacement and modified stock looms for our musclecars.

M & H deals directly with the general public, and has the web site:

www.wiringharness.com

Hope this direct link works, first time I have tried it.



[This message has been edited by IgnitionMan (edited 12-19-99).]
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top