Team Chevelle banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
How is the best way I can clean up the fuse terminal block. Mine is not so much corroded but a little rusty. This causes one or more parts of my electrical system to go out at any time. There is nothing wrong with the wiring and everything workes after wiggling wires and holding my breath. But it's hard to do that driving down the road.
Thanks

Chip
1965 Mailbu SS
 

·
Registered
Joined
·
3,177 Posts
Wd-40 works great for cleaning corroded electrical contacts. Use that in combination with a dremel with a rotary brush that will fit in the fuse slot just like noneck did.
You can back the center bolt out of the fuse block from the firewall side and pull the harness off the firewall. The connection prongs sticking out can be cleaned by some 350 grit wet or dry w/wd-40 or you can take a pair of pliers and gently squeeze the prong and then pull the wire out from the other side. This will let you file/sand/scrape or whatever to clean the prong. To make sure it stays in when you put it back, use a thin flat blade screwdriver and gently open the prong.

Dave
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top